Waeco SinePower SP700 Bedienungsanleitung Seite 32

_MSK.book Seite 32 Montag, 26. Februar 2007 10:15 10
Connecting the inverter
Connecting MSK700, MSK1000, MSK1500
➤ Unscrew the bolt (4 1, page 3) from the red positive terminal (7 2, page 4).
➤ Push the cable lug (4 2, page 3) of the positive cable into the positive
terminal (4, page 3) and fasten it with the bolt.
➤ Connect the negative cable to the black negative terminal (7 1, page 4).
➤ Connect the earth terminal (7 3, page 4) to the chassis.
Connecting MSK2000, MSK3000
➤ Pull the red plastic cap (5 1, page 4) off the positive terminal (8 2, page 4).
➤ Remove the nut (5 2, page 4) from the positive terminal (8 2, page 4).
➤ Take the split washer and the washer (5 3, page 4) off the connecting
pin.
➤ Push the cable lug (5 4, page 4) of the positive cable onto the connect-
ing pin of the positive terminal (8 2, page 4) and fasten it with the
washer, the split washer (5 3, page 4) and the nut (5 2, page 4).
➤ Push the plastic cap (5 1, page 4) onto the positive terminal
(8 2, page 4).
➤ Connect the negative cable to the negative terminal (8 1, page 4).
➤ Connect the earth terminal (8 3, page 4) to the chassis.
Connecting the inverter to the battery
➤ Lay the positive cable from the inverter to the positive terminal of the
vehicle battery and connect it there.
➤ Lay the negative cable from the inverter to the negative terminal of the
vehicle battery and connect it there.
32
SinePower