Re-Thread The Collar - Petsafe Pawz Away Gebrauchsanweisung

4. Adjust the tightness of the Receiver Collar
to fit your pet's neck. Check the tightness
of the Receiver Collar by inserting one
finger between the end of a Contact Point
and your pet's neck. The fit should be snug
but not constricting (4B).
5. Allow your pet to wear the Receiver
Collar for several minutes then recheck
the fit. Check the fit again as your pet
becomes more comfortable with the
Receiver Collar.
6. Once you are satisfied with the fit of the
Receiver Collar then you may trim any
excess collar strap as follows (4C):
A. Mark the desired length of the
Receiver Collar with a pen. Allow for growth if your pet is young or grows a
thick winter coat.
B. Remove the Receiver Collar from your pet and cut off the excess.
C. Before placing the Receiver Collar back onto your pet, seal the edge of the cut
collar by applying a flame along the frayed edge.

Re-Thread the Collar

Ridges
10
Slide Buckle
www.petsafe.net
4B
4C
The slide buckle prevents the collar from
becoming loose around your pet's neck.
The ridges must be facing up; the collar
will slip if it is not properly threaded.