Set Up The Barrier Transmitter; Test The Barrier Area - Petsafe Pawz Away Gebrauchsanweisung

STEP 2

Set Up the Barrier Transmitter

To prevent an unintended stimulation, never perform set-up procedures
while your pet is wearing the Receiver Collar.
1. With the back of the Barrier Transmitter facing up, rotate
back cover counter-clockwise, removing the back cover.
Install three (3) AAA alkaline batteries and replace the
back cover. Turn clockwise to secure cover.
2. Turn the Barrier Transmitter right side up and press the (+)
button once to turn ON the Barrier Transmitter. A black bar
in the upper right hand corner of the LCD display window
indicates that the Barrier Transmitter is set to mode A* (2A).
3. A second black bar in the bottom of the LCD display
indicates the range is set to one segment. Each segment represents approximately
13 cm from the unit. You can create a Barrier Area of 13 cm to 76 cm from the unit.
Using the (+) and (-) buttons, adjust the range to fit the desired pet Barrier Area.
* All Mini Pet Barriers and Receiver Collars are preset to mode A. For single pet
households, you will not need to operate the Barrier Transmitter in any mode other
than A. The A and B modes are for use in multiple pet households where you may
want one pet to be able to access an area while preventing access by another pet.
Please see the Additional Features section of this operating and training guide for
instructions on how to utilise modes A and B.
STEP 3

Test the Barrier Area

1. Keeping your hands away from the Contact Points,
use the edge of the Test Light Tool to turn the
receiver battery door to the ON (l) position.
2. Hold the Receiver Collar with the Contact Points
facing up and the PetSafe
Transmitter. Place the Test Light Tool on the Contact
Points so that the wire in the Test Light Tool touches
the Contact Points (3A).
logo facing the Barrier
®
www.petsafe.net
2A
3A
7