Key Definitions; Fit The Spray Collar - Petsafe PBC17-16193 Gebrauchsanleitung

Key Definitions

Spray Nozzle: Where the spray ejects when your dog's bark
is detected.
Sound Activated Sensor: Detects the sound of your
dog's bark.
Refill Port: Where the spray is refilled.
Yellow LED: Low spray indicator.
Two Colour LED: Shows good or low battery.
On/Off Battery Module: Turns the Spray Collar on and off,
and resets the spray counter.

Fit the Spray Collar

Important: The proper fit and placement of your Spray Collar is
important for effective operation. To assure a proper fit, please follow
these steps:
1. Make sure that the Spray Collar is turned off.
2. Start with your dog standing comfortably (A).
3. Place the Spray Collar high on your dog's neck close to the ears.
Centre the unit underneath your dog's neck with the spray nozzle
facing upward (B).
4. Check the tightness of the Spray Collar by inserting one
finger between the collar and the back of the dog's
neck. The fit should be snug but not constricting (C).
5. Allow your dog to wear the Spray Collar for several
minutes, then recheck the fit. Check the fit again as your
dog becomes more comfortable with it.
6. Trim the Spray Collar as follows (D):
a. Mark the desired length with a pen. Allow for
growth if your dog is young or grows a thick
winter coat.
b. Remove the Spray Collar from your dog and
cut off excess.
c. Before placing the Spray Collar back onto
your dog, seal the edge of the cut collar by
applying a flame along the frayed edge.
7. The PetSafe
®
can quickly attach and remove the Spray Collar
from your dog while maintaining the desired fit.
Once the fit is determined, simply use the Snap
Buckle to remove and replace the Spray Collar.
6
QuickFit collar is designed so you
™
B
C
D
petsafe.com
On/Off
Two
Battery
Sound
Colour
Module
Activated
LED
Sensor
Yellow
LED
Spray
Nozzle
Refill Port
A
YES
NO