Procedure In The Event Of Malfunction; Overvoltage; Overheating; Overloading - VITRA CDS Bedienungsanleitung

Procedure in the event of malfunction

EN
! CAUTION!
Immediately disconnect the power sup-
ply in the event of a malfunction, e.g. emission of smoke or
odours, unusual noises, other malfunctions or operational fail-
ures. Contact your Vitra retail partner.

Overvoltage

! DANGER!
To avoid the risk of injury and damage
to property caused by surges of current:
• Disconnect the power supply during assembly and mainte-
nance work.
• Immediately disconnect the power supply in the event of
a malfunction, e.g. emission of smoke or odours, or unusual
noises.
• Disconnect the power supply during thunderstorms and long
periods of absence.
• Keep fluids out of plug connections.
• Do not use damaged power cables. Ensure damaged pow-
er cables are replaced by Vitra Service or by a qualified
electrician.
18

Overheating

! CAUTION!
To avoid the risk of injury caused by over-
heating:
• Give the table a break of at least 18 minutes after a maximum
duty cycle of 2 minutes.
• Immediately give the table a break of at least 18 minutes
when there is a reduction in speed, as this shows the begin-
ning of overheating.

Overloading

! ATTENTION!
Optimal pillar function with spread load:
• max. 35 kg per leg stand
max.
35 kg

Noise emission

The noise emission while in use is <50 dBA.
max.
35 kg