Operating Instructions - Flex AL 10 Bedienungsanleitung

Operating instructions

Before switching on the
power tool
Unpack the power tool and check that the
delivery is complete and not damaged.
Before using the machine for the first time,
insert batteries.
Using batteries in the power tool
Required batteries:
– 2 x type AAA / 1.5 V
n Open the battery compartment (8)
on the machine.
n Insert the batteries the correct way
round.
n Close the battery compartment.
Attaching the machine
Note
For optimum results it is recommended to
attach the machine to a tripod (accessory).
– Tripod thread (6): 1/4"
The machine can also be attached to
suitable surfaces with the magnet (7).
Switching the power tool on
and off
n Press the On/Off button (9).
Switching over the operating
mode
Note
The laser head can be adjusted steplessly,
it has notches in 90° steps.
To switch over the operating mode, rotate
the laser head (5) into the required position.
12
– Laser point
– Laser line horizontal
– Laser line vertical
Operating the machine
n Attach the machine in the required
position (horizontal, vertical, 45°).
n Align the machine with the aid of the
appropriate spirit level (2, 3, 4).
n Switch on the machine.
n Select the operating mode according
to requirement.
n Set the laser line to the required position
by swivelling the laser head.
On completion of work:
n Switch off the appliance.
Line laser