Floor Cleaning - Kärcher FRV 30 ME Bedienungsanleitung

 Adjust the wrench area of the nozzle
(width 10) so that it is parallel to the ro-
tation arm.
 Tighten the Union joint (width 22) using
a wrench.
 Repeat the process on the second rota-
tion arm.
Note:
Do not attach the nozzles for the surface
cleaner to the spray lance of the high-pres-
sure cleaner.
1 Injector nozzle
2 Wrench
 Screw the injector nozzle into the injec-
tor using the wrench and tighten it fin-
gertight (8 Nm).
The wrench is included with the nozzle
set.
10

Floor cleaning

 Connect the steel pipe of the high pressure
cleaner to the surface cleaner and tighten
it with a wrench (opening width 24).
Caution
A strong wastewater jet will emerge from
the hose connection. Do not use the sur-
face cleaner without a hose.
 Grease the O-ring at the end of the
hose using the accompanying grease
prior to installation.
 Insert the accompanying hose at the
hose connection of the surface cleaner
and secure it by turning.
 Route the other end of the hose to a
drain and secure it by means of the ac-
companying hook-and-loop tape.
Note:
If possible, lay hose without any slopes.
Maximum delivery height of the waste wa-
ter is 1 m.
The free end of the hose can be attached
by means of the included Velcro tape (e.g.
on a drain grid).
If necessary, use extension hose (see "Ac-
cessories").
 Hold the hand spray gun and the spray
pipe firmly with both hands.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
– 3
EN