Examples Of Connection; Installation; Pin Assignment - Oventrop Rbg-C K Installationsanleitung

3 Dimensions
4

Installation

Before work commences, please ensure that the appliance is
disconnected from the power supply. The electrical connection
must only be carried out by a qualified electrician.
The room controller "RBG-C K" requires a 24 V/ 50 Hz power
supply via two cores with a sufficiently dimensioned conductor
cross section.
The safety notes of the installed transformer must also be
observed.
Drill hole dimensions
Fixing points for flush socket
5

Pin assignment

Designation Description
Terminal Permissible cable cross sections: 0.34
...2.5 mm² (flexible), 0.34 ...1.5 mm²
(rigid)
1 L1 AC 24 V, power supply
2 L2 GND GND , ground connection
3 A
C-bus, bus interface
4 B
5 A DI: Digital input
for wired window contact or movement
6 B
sensor
7 DO PWM Digital output or PMW output for two
point actuators (24V AC)
8 - Supporting terminal, without internal
connection
9 AO 0-10V Output 0 ...10V, for steady actuators
10 - Supporting terminal, without internal
connection
11 - -
12 - -
6

Examples of connection

Electromotive actuator
steady
*wired window contact or movement sensor
Electrothermal actuator
Two point
*wired window contact or movement sensor
- 2 -