Cleaning The Filter Frame; Cleaning The Fine Dust Filter; Starting The Comfortclean Self-Cleaning Function Manually; When To Change The Thread Lifters - Miele HS16 Gebrauchsanweisung

 Press the yellow release catch on the
bottom of the dust container.
The flap will open and the dust will fall
out.
 Close the flap so that it audibly clicks
into place.
 Insert the dust container into the va-
cuum cleaner from above so that it
audibly clicks into place.
 Push the handle down.
Cleaning the dust container
Clean the dust container as required.
 Clean the dust container using water
and mild washing-up liquid.
 Dry the dust container thoroughly.
Cleaning the filter frame (dia. 25 + 26)
A removable filter frame is located in the
dust container. This should be cleaned
if it is obviously dirty.
 Place the emptied and open dust
container on its front.
 Release the filter frame and remove it.
 Empty the filter frame and rinse it un-
der cold running water.

Do not use washing-up liquid!
Do not use any sharp or pointed ob-
jects!
Dry the filter frame carefully!
 Replace the dry filter frame in the
dust container so that it audibly clicks
into place.

Cleaning the fine dust filter

The fine dust filter is equipped with a
self-cleaning function. When a specified
degree of soiling is reached, the va-
cuum cleaner switches off automatically
for approx. 20 seconds and carries out
a cleaning process. You will hear this
process running.
The ComfortClean button on the va-
cuum cleaner lights up yellow.
Starting the ComfortClean self-clean-
ing function manually (dia. 27)
If a large amount of dust has been va-
cuumed at once, the ComfortClean
self-cleaning function should be started
manually either during a vacuuming
pause or immediately afterwards. This
enables the vacuum cleaner to achieve
the very best cleaning performance
again straight away.
 With the vacuum cleaner switched
on, press the ComfortClean button
for at least two seconds.
The vacuum cleaner is switched off
automatically for approx. 20 seconds
and a cleaning process is carried out
which results in operational noise.
The ComfortClean button on the va-
cuum cleaner lights up yellow.
The vacuum cleaner will then switch
back on automatically and will operate
with the previously selected setting.
We also recommend emptying and
cleaning the fine dust container once or
twice a year (see "Fault resolution –
Cleaning the fine dust filter manually").

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)
en
39