User Interface Of The Telephone - Funkwerk elmeg CS290 Bedienungsanleitung

English

User interface of the telephone

1 Function button: This key opens the programming menu. If you are already located in a menu
and then press the key, either menu-specific functions are shown, or you are moved back one
programming step.
2 Escape button: Pressing the Esc button during programming returns the telephone to its idle
status.
3 3 softkeys
The functions of the softkeys are displayed in capital or small letters (depending on your set-
tings).
4 Display: Thedate and timeappear onthetop lineof thedisplay whenyou connect theunitto the
power supply system (IPS 290), or to the internal ISDN or UP0 (CS 290, CS290-U) port of the
PABXsystem.Thedateandtimeareimportedautomaticallyfromthepabxsystem.Thetextdis-
played for a function on line 2 is always located above the corresponding softkey. When you
press the softkey, the next level is displayed.
If not all information fit into the screen, this will be indicated by »
5 OK button: Pressing this button stores a setting in the telephone. You then hear the acknowled-
gement signal.
6 Ckey:Pressthisbuttontomovebackonemenustepinthemenu.Ifyouarecurrentlyintheinput
mode, this button can be used to delete individual characters.
7 Call-LED: Incoming calls are signaled by a rapidly flashing LED.
8 Speaker
9 Open listening (hands-free button IP-S290)
10 Ending a call
2
« or » «.
« «