Electrical Work - Mitsubishi Electric CITY MULTI PLFY-WP10VFM Installationshandbuch

5. Electrical work

A
B
H
J K F E
G
JKL
55 mm
12 mm
Fig. 5-1
CN5Y
Fig. 5-2
Cable strap
Be sure to connect the remote
locations shown in the diagram.
8
C
I
D
C
M
M
F
Secure with a band 3 (small) at the location
shown in the diagram
CN4Z
CN90
indoor-outdoor connection cable
with the cable strap.
1. Loosen the two screws securing the electric component cover, and then slide and
remove the cover.
2. Route each cable through the wiring intake into the electric component box. (Procure
power supply cable and control cable locally.)
3. Securely connect the power supply cable and control cable to the terminal blocks.
4. Secure the wires with the cable straps inside the electric component box. Secure
the wires with cable straps as cushioning components so that no stress is applied
to the connecting sections of the terminal block when tension is generated.
5. Attach the electric component cover as it was.
Always install earth.
(Earth cable dia: Thicker than 1.6 mm)
bushing for tensile force. (PG connection or the like.)
A
Electric component cover
B
Electric component box
C
Entry for power supply cable
D
Entry for remote control cable and trans-
mission cable
E
Cable clamp
F
Power supply terminals (L, N)
L
Caution:
junction cables.
■ When using the panel with wireless signal receiver or i-see sensor, install
wireless junction cable for connecting with the cable from the panel through
the following steps before installing the main unit.
Signal receiver: CN90
i-see sensor: CN5Y
i-see sensor motor: CN4Z
(mm)
Warning:
stress is applied to the connecting section of the terminal block. Incomplete
G
Transmission terminals (M1, M2, S)
H
MA Remote controller terminal (1. 2)
I
Indoor controller
J
Remote control cable
K
Transmission cable
L
Power supply cable
M
Cable strap