Installation; Connecting The Camera; Video Connection; Remote Control Via The Jack Control - Monacor TVCCD-1622COL Bedienungsanleitung

4 Installation

The camera can be installed on a camera stand, on a
pan/tilt head (e. g. MONACOR VPT-50), or on a camera
support (e. g. support of the MONACOR TVH series). For
mounting, the lower side of the camera is provided with an
adapter (11) with thread jack [6.3 mm (
suspension of the camera, this adapter can alternatively
be screwed to the upper side of the camera.
For outside installation, the camera must be placed in a
weatherproof outdoor housing.

5 Connecting the Camera

5.1 Video connection

Connect the BNC jack VIDEO (8) via a 75 Ω cable (e. g.
MONACOR BNC-1000) to the video input of the following
unit (e. g. monitor, video recorder). With a cable length
exceeding 100 m, a video amplifier should be inserted be-
tween the camera and the cable to compensate cable loss.

5.2 Remote control via the jack CONTROL

Via the 6-pole jack CONTROL (5), the camera can be re-
mote-controlled: alternatively via the RS-485 interface or
via Pin 3 with five separate momentary pushbutton switches.
Pin
1 /
") thread ]. For
4
1
2
3
4
5
6
Fig. 5 Pin configuration of the jack CONTROL
For connection, a 6-pole plug is supplied with the camera.
The core colours of the cable can be found in the table of
fig. 5.

5.2.1 Control via RS-485 interface

1) Connect Pin 4 (B) and Pin (A) of the jack CONTROL to
the corresponding contacts on the controller. Connect
the screening to Pin 2 (ground).
Note: Interference will be reduced when using twisted
cables.
Colour Function
red 12 V or external unit
black ground
white remote control via MPB switches
yellow RS-485 (B)
green RS-485 (A)
grey day/night mode
GB
CONTROL
1 6
19