Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WV36M/SSI
16
Commissioning
Admissible power input
Supply for the absolute encoder shall be sized sufficiently. The voltage
values are a function of the device design and can be referred to in the
technical data in chapter 8.
Pin assignment
• Plug pin 8 pin (M12 A-coded)
For mating connector and cable extension accessories see chapter 7.
PIN
Designation
1
GND
2
+UB
3
SSI Cycle +
4
SSI Cycle -
5
SSI Data +
6
SSI Data -
7
Calibation input
8
Counting direction
5 Commissioning
Calibration
Connect input for at least 1 second to '1' (24 V DC) and then to '0' (GND).
With this slope encoder value is set to position value 0.
For interference reasons idle preset input must be connected to GND.
Counting direction
Counting direction is defined by corresponding input.
Voltage
Counting direction
'0' (GND)
I = with clockwise rotation increasing values (viewing
onto the shaft)
'1' (24 V DC)
E = with clockwise rotation decreasing values
Modification is made after approx. 1 second only.
WV36M/SSI · Date 24.08.2016 · Art. No. 85487 · Mod. status 203/16
English
viewing side = plug-in side
Werbung
Kapitel
Inhaltsverzeichnis
