Electrical Installation - Siko WV36M/SSI Originalmontageanleitung

WV36M/SSI
Installation
Forfeiture of guarantee
CAUTION
Improper coupling of the shaft, e. g. by using rigid couplers that exert
excessive force on the bearing of the shaft.
` For solid-shaft encoders use SIKO's compensating coupling, type
Absolute encoder failure
CAUTION
` When mounting pay attention to the IP type of protection (see chap-
` Do not open the absolute encoder yourself.
` Avoid impact on the device.
` Do not modify the device in any way.
Loss of type of protection
NOTICE
Sealing rings in the ball bearing are wearing parts! Therefore, the type of
protection depends on the service life and condition of the sealing rings.
Mounting the encoder
• Fasten the encoder by means of screws or servo clamps and clamping
• No forces must be transferred through the housing. Forces must act

4.2 Electrical Installation

Destruction of parts of equipment and loss of regulation control
WARNING
` All lines for connecting the absolute encoder must be shielded.
` Never wire or disconnect electrical connections while they are live.
` Perform wiring work in the de-energized state only.
` Use strands with suitable ferrules.
` Check all lines and plug connections before switching on the device.
` Switch on operating voltage together with the downstream electronic
Basically, all connections are protected against external interference.
Choose a place of operation that excludes inductive or capacitive inter-
ference influences on the absolute encoder. When mounting the system
keep a maximum possible distance from lines loaded with interference. If
necessary, provide additional installations including screening shields or
metallized housings.
WV36M/SSI · Date 24.08.2016 · Art. No. 85487 · Mod. status 203/16
AK18.
ter 8).
of the shaft. Take care to mount the encoder free from distortion.
exclusively on the shaft of the instrument.
unit (e. g., control unit).
English 15