Kopp Free-control Bedienungsanleitung Seite 58

GB
Operating procedure
For wireless adapter with dimmer function:
• DIMMER for conventional transformers
(phase control dimmer)
Switching the DIMMER ON / OFF:
Briefly press the programmed wireless trans-
mitter button: dimmer is switched "ON"
Briefly press the programmed wireless trans-
mitter button again: dimmer is switched
"OFF"
Switching the DIMMER ON and dimming it:
Briefly press the programmed wireless trans-
mitter button and hold down: dimmer is
switched "ON" and the brightness of the con-
nected lamp is increased from "minimum" to
"maximum".
This means that the brightness of the con-
nected lamp is first increased to maximum
and then decreased again.
This procedure is constantly performed as
long as the wireless transmitter button is
pressed. As soon as the desired lamp bright-
ness has been reached, release the wireless
transmit button and do not press again. The
set brightness is maintained until the DIM-
MER is adjusted again or switched off.
58
When the dimmer is switched off and on
again, the light switches on with the last set
brightness. (memory function)
For wireless adapter:
• SWITCH, 3-wire 1-channel
Switching the SWITCH ON / OFF:
Briefly press the programmed wireless trans-
mitter button: SWITCH is switched "ON".
Briefly press the programmed wireless trans-
mitter button again: SWITCH is switched
"OFF". The wireless adapters can be operat-
ed in so-called one-button mode as well as
two-button mode.
Exception: wireless adapters with dimmer
function.
The devices can only be programmed and op-
erated in one-button mode.
One-button mode:
For this, use the same wireless transmit but-
ton or use the same switching position for the
ON and OFF switching process of the wireless
wall-mounted switch.
Two-button mode:
For this, use a wireless transmit button or use
two different switching positions for the ON
and OFF switching process of the wireless
wall-mounted switch..