Kopp Free-control Bedienungsanleitung Seite 57

GB
• Then, trigger a radio signal with the desired
wireless transmitter within 20 seconds.
• The LED of the wireless adapter
4
goes out 1x, if the radio signal has been
received and saved by the wireless adapter.
• If the memory has been programmed, the
LED blinks 4 3x.
• It is not possible to program a wireless
transmitter to the same wireless adapter
numerous times. In this case, the LED
blinks rapidly.
4
4
• Finished – The wireless adapter and wire-
less transmitter are now connected to each
other via radio link.
• The system automatically exits the pro-
gramming mode after 20 seconds.
• In order to exit the programming mode
prematurely, press the PROG button on the
wireless adapter again. (Use the program-
ming stylus for this).
• As soon as the programming mode has
been exited automatically or prematurely,
the LED 4 goes out.
• After the wireless transmitter has been lin-
ked to the wireless adapter, the installation
of the wireless adapter can be finished.
(Follow the tips for planning.)
57