Maintenance; Routine Maintenance - Gaspardo FBR Plus Gebrauch Und Wartung

ENGLISH

4.0 MAINTENANCE

The various servicing operations are listed in the following
paragraphs. Lower running costs and longer machine life depend
on constant and methodical compliance with these operations.
During work and maintenance operations, use suitable perso-
nal protection gear:
- The given frequencies are indicative and refer to normal
conditions of use. They may therefore be subject to variations
in relation to the type of service, a more or less dusty
environment, seasonal factors, etc.
- In the case of heavy-duty conditions, the maintenance
operations should obviously be more frequent.
- Before injecting grease into the lubricators, the greasing
points must be thoroughly cleaned to prevent mud, dust or
foreign bodies from mixing with the lubricant, thus reducing
or even annulling its lubricating effect.
ATTENTION
It is absolutely essential to disengage the tractor pto, lower the
mowing machine, switch off the tractor, ensure that this is at a
complete standstill and remove the key before servicing, adjusting
or preparating the implement for work. All assembly operations
must be carried out on a work bench.
- Always keep oils and greases well away from children's
reach.
- Always thoroughly read the warnings and precautions
indicated on the containers.
- Avoid contact with the skin.
- Always thoroughly and fully wash after use.
- The utilized oils should be treated in compliance with the
current laws in force.

4.1 ROUTINE MAINTENANCE

- During the first working hours, check that the screws are tight
(Fig. 42).
EVERY 2 WORK HOURS
- Grease points (A-B, Fig. 32).
EVERY 8 WORK HOURS
- Grease the cardan shaft cross journals.
- Adjust belt tension periodically by adjusting nut (J, Fig. 33).
Check tension via the viewing panel on the belt guard. Belt slack
must not exceed 2 cm. It is essential to close the inspection
hatch with the relative lid after the belts have been examined.
EVERY 50 WORK HOURS
- Check the tightness of the connecting rod bolts regularly (Fig.
34).
PERIODICALLY (6 MONTHS)
- Grease point (A-B, Fig. 32).
AFTER EACH MOWING JOB
- Clean and oil the mowing bar blades according to the
instructions in the chapter entitled: "Cleaning and oiling the
cutters".
38
CAUTION
USE AND MAINTENANCE
Fig. 32
J
g
B
A
Fig. 33
Fig. 34
cod. G19503010