Description Of The Mower; Technical Data; Use And Maintenance - Gaspardo FBR Plus Gebrauch Und Wartung

ENGLISH

1.3 DESCRIPTION OF THE MOWER

This agricultural implement can only operate by means of a cardan
shaft applied to the pto of an agricultural tractor equipped with lift
and universal three-point hitch.
Since it is movable, the mowing machina can be easily mounted
on tractors with different gauges or on tracked vehicles (Fig. 2).
The two-motion tooth-blade system used in mowing machines,
makes possible a scissors cut which leads to a higt speed
operation on a any crop.
The original tooth-blade motion guarantees a sharp and clean
cut on any type of grass, be it damp or flattened. It is thanks to the
total absence of soil which this mowing system does not raise,
sharp because the stems are not frayed.
The mower may also be used with the cutting arm tilted for
working on canals, ditches, embankments. (Fig. 3 and 4).
The lifting system of the mowing bar can be mechanical or
hydraulic according to choice. In this manual instructions are
given for the mechanical system only.
To install and use the hydraulic system refer to the manual (code
G19503040) supplied with the accessory. The manual must be
kept in a safe place so that it can be referred to during the whole
of the machine's operating life.
ATTENTION
The mower is suitable only for the uses indicated. Any other
use different from that described in these instructions could
cause damage to the machine and represent a serious hazard
for the user.
It is therefore advisable to strictly comply with the following
instructions in order to prevent faults which could jeopardize the
correct and long-lasting operation of theimplement. Compliance
with the instructions in this handbook is also important since the
Manufacturer declines all and every responsibility for damage
to persons or property caused by negligence and failure to
comply with these instructions. The Manufacturer shall, however,
remain at the customers' disposal for immediate and thorough
assistance together with anything else that may be required in
order to ensure the correct operation and maximum efficiency of
the implement.

1.4 TECHNICAL DATA

Cutting arm lenght
Weight
Power take-off revs
Schinitt (max)
Power required
No-load noise detection (*)
(*) L = Acoustic power level uttered by machine (Weighed A);
WA
L = Continuous equivalent acoustic radiation pressure level (Weighed A) in the "worker's position".
pA
The technical data and the models provided must be considered as non binding. We reserve the right to change them without
notice.
26

USE AND MAINTENANCE

Fig. 2
Fig. 3
Fig. 4
U.M.
[m] 1,75
[kg] 230
[r.p.m.]
[Km/h]
[HP - (kw)]
[dB]
g
FBR Plus
2,05
238
540
10÷12
25 - (19)
(L = 110,7) - (L = 91,7)
WA pA
cod. G19503010
2,35
246