Assembly
Requirement for assembly
You have read chapter For your safety" on
page EN-4 and understand all the safety no-
tices.
Installing check valve
(4)
Stifte
1. Place the two halves of the check val-
ve (4) into the opening on the top of the
Exhaust hood (1).
Make sure that the pins on the valve are
facing outwards.
Assembling the exhaust hood
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
196366_EN_20190108.indd EN-11
196366_EN_20190108.indd EN-11
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas stoves.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
(4)
1. In order to place the appliance exact-
ly over the centre of the stovetop, first
use the pencil to draw a vertical guiding
line on the wall. Ideally, use a level or a
plumb bob from the ceiling of the room to
the middle of the stovetop.
2. Hold the exhaust hood (1) against the
wall so that the distance to the stove is at
least 65 cm and the centre of the exhaust
hood aligns with the guide line.
3. Put the exhaust hood aside carefully.
Page EN-11
Assembly
guideline
08.01.2019 14:02:40
08.01.2019 14:02:40