AEG DVD 4615 HC Bedienungsanleitung Seite 64

English
64
05-DVD 4615 HC_GB.indd 64 05-DVD 4615 HC_GB.indd 64
Dolby Digital Setup
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to
choose Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
L-Mono: The Audio output is in Mono. In this case the signal of the
„left" stereo channel is transmitted to all speakers.
R-Mono: The Audio output is in Mono. In this case the signal of the
„right" stereo channel is transmitted to all speakers.
Mix Mono: The Audio output is in Mono. In this case the signal of the
„both" stereo channel is transmitted to all speakers.
Dynamic
The term „Dynamic" (Dynamic Range) describes the ratio of quietest and
loudest sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are watching a
DVD in a relatively loud environment. You can now increase the volume to
be able to hear also the very quiet passages, however with the disadvan-
tage that loud passages will be unacceptably loud. In this case it would
make sense to compress the dynamic range (i.e. reduce) and increase the
output volume at the same time.
FULL -1/8: The dynamic range is compressed slightly (1/8) to full
(FULL).
OFF: The dynamic range is not compressed at all (default).
Channel Delay
If you use a 5.1-Audio system, you may experience a distortion of the
sound impression caused by the distance diff erences between speaker
groups and listener. Sounds that should be heard by the listener at the
same time arrive successively.
Here you can delay the sound produced by the central and rear loudspea-
kers or subwoofer in order to produce a more balanced sound for the
listener.
Select the individual loudspeakers with the Cursor buttons ( / ).
Use the Cursor buttons ( / ) to perform the adjustments.
Equalizer
In this menu you can set various sound options.
21.05.2008 8:08:30 Uhr 21.05.2008 8:08:30 Uhr