Connecting The Video Cable - AEG DVD 4615 HC Bedienungsanleitung

English
50

Connecting the Video cable

Fig. 2/19
Fig. 2/20
Fig. 2/25
Fig. 2/18
05-DVD 4615 HC_GB.indd 50 05-DVD 4615 HC_GB.indd 50
The video cable transmits the video data from your DVD-Player to the TV
or the Video-Projector.
There are four diff erent ways of connecting the DVD-Player with your TV/
Video-Projector. Select one of these possibilities to suit your replay unit.
NOTE:
If you do not use a SCART connection it is necessary to make an
additional audio connection for the transmission of the audio data
(i.e. the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback
device.
Component Video
Connection using a Component Video cable ensures a very high replay
quality.
Component Video transmits only Video signals.
1. Plug each of the three jacks into the corresponding sockets on the
DVD-Player.
2. Plug the jacks into the corresponding socket on your playback device.
Select „Video Output" from the menu „Video Setup Page". Here you
can change the settings „Off ", „YUV and „P-YUV" on the playback
device that you have connected. Please see the operating instructions
of the connected device for the correct setting.
S-Video
Connection using a S-Video cable ensures a very high replay quality.
Component Video transmits only Video signals.
1. Plug the S-Video jack into the socket on the back of the player.
2. Plug the S-Video jack into the corresponding socket on your playback
device.
Composite-Video
Composite-Video is used to transmit both Video data.
1. Plug the Composite-Video jack into the socket on the back of the
player.
2. Plug the Composite-Video jack into the corresponding socket on your
playback device.
21.05.2008 8:08:24 Uhr 21.05.2008 8:08:24 Uhr