Hendi 239711 Gebrauchsanweisung Seite 9


Make sure the appliance is not set up near water vapour or greasy vapours. The fan of the
appliance will take in these vapours and this will cause grease or moisture to accumulate in the
appliance which may result in a short-circuit in the appliance. Clean the grease filter regularly
Preparations before using for the first time
•
Check to make sure the appliance is undamaged. In case of any damage, contact your supplier
immediately and do NOT use the appliance.
•
Remove all the packing material.
•
Clean the appliance with luke-warm water and a soft cloth.
•
Level the appliance.
•
Make sure that a clearance of 15 cm is maintained around the appliance with respect to
ventilation of the appliance.
•
Position the appliance in such a way that the plug is accessible at all times.
Suitable cooking equipment
•
Only use pans that have the following properties:
o The pan must be suitable for induction. The following logo is usually displayed on the
bottom of the pan:
Should you inadvertently use a pan that is not suitable for induction, it will not be recognised
by the appliance, which will beep a number of times and switch to the stand-by mode.
o The bottom of the pan must have a diameter of 12 cm, at minimum. This means that the
smallest circle on the glass plate of the appliance may NOT be visible when the
appliance is in use.
Should you inadvertently use a pan that is too small, the appliance will beep a number of
times and switch to the stand-by mode.
o The used pan must NOT have a diameter of more than 28 cm. This means that the
outermost circle on the glass plate of the appliance may be visible when the appliance
is in use.
The appliance may be damaged if a larger pan is used.