Hendi 239711 Gebrauchsanweisung Seite 10

The control panel
1. "Temp/ heating" key: Use this key to select the required function. The function that is selected is
indicated by the lights. You can opt to set the power level (Power), or the temperature (Temp),
both in combination with the timer.
2. "ON/OFF" key: Use this key to switch the appliance on or to interrupt or reset the timer.
3. "Arrow" keys: Use these keys for programming the capacity, temperature or time. The up arrow
increases the setting value and the down arrow reduces the setting value.
4. These lights indicate what mode you have selected by means of the "Temp/heating" key.
5. You can read the programmed value on this display. The steps for capacity control are from
100W to 3500W, 35°C to 240°C for temperature control and from 0 to 180 minutes for time
settings.
Operation
•
Put the plug in the socket.
•
Set the pan of your choice on the cooking surface, bearing the above-mentioned instructions in
mind.
NOTE! Make sure that the pans are covering the indicated zones at all times during use in order
to prevent the appliance from getting damaged.
NOTE! Do not leave your pan on the burner while empty as this may lead to damage to your
pans.
•
Switch the appliance on by pressing the "ON/OFF" key. If your pan is suitable for induction and
has a bottom diameter of 12 cm, at minimum, the appliance will go into operation. You will
recognise this from the fact that the fan will go on and the display will show a capacity position of
"2000".
NOTE! If the appliance beeps after being switched on, the pan you are using is not suitable for
induction or the appliance is defective. In case of any doubt, always contact the supplier of
your pan!
•
Once the appliance is operating and the display indicates position "2000", you can programme
the appliance in one of the following two ways:
o Capacity control: You can control the performance of the appliance, just as for a gas
cooker via 17 positions ranging from 100W to 3500W.
The default position for the appliance is "2000".
o Temperature control: you can set the temperature between 35°C and 240°C in 5°C
increments. Standard position for the appliance is 100°C. ATTENTION! The
programmed temperature is that of the glass plate and not the temperature in the pan!
•
If you choose capacity control, select "heating" using the " Temp/heating" key. Now you can
programme the capacity required by means of the arrow keys, 3500W being the highest and
100W the lowest position.
•
If you select temperature control, select "Temp" using the "Function" key. Now you can
programme the required temperature by means of the arrow keys between 35°C and 240°C in
5°C increments.
•
After programming the capacity or temperature, you can opt to programme the timer. This timer
switches the appliance off after the programmed time has been reached. You do this by pressing
the "Timer" key once more after programming the capacity or temperature, and selecting "Timer".
You can now set the desired time. The maximum programmable time is 180 minutes.
•
Once you have reached the required result, you can switch off the appliance by pressing the
"ON/OFF" key. The display will go off and the lights next to "Power", "Temp" and "Timer" will go
off.
•
If you do not use the appliance for an extended period, remove the plug from the wall-mounted
electrical socket and remove the pans from the appliance.
NOTE! Allow the appliance to cool off before you touch it. The glass plate is very hot after use.