Cleaning And Storage; Troubleshooting Guide - Cocraft LXC series Original Bedienungsanleitung

Cleaning and storage

• Clean the exterior of the rotary hammer drill with a soft brush or cloth. Never use
water, solvents or corrosive chemicals for cleaning.
• Regularly remove all dirt, especially from around the motor ventilation slits.
• Store the rotary hammer drill in a dry place out of children's reach whenever it is
not to be used for a long time.

Troubleshooting guide

The rotary hammer
drill will not start.
The rotary hammer
drill is sluggish
and/or shuts off.
Poor battery
operating time.
The battery does
not charge.
Responsible disposal
This symbol indicates that this product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner. When
recycling the product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is disposed of in
an environmentally sound manner.
Discharged or incorrectly inserted battery. Charge the battery
and ensure that it is properly connected.
• Worn/damaged accessory. Change the accessory.
• Too much force applied. Decrease the applied force.
• The battery might be overheated. Refer to the section Over-
load protection and other safety features.
• The battery is not fully charged. A few charging cycles
where the battery is charged 100% might be needed before
it reaches full capacity.
• The battery needs replacing.
• The battery is not correctly inserted into the charger.
• The battery or charger contacts are dirty. Disconnect
the charger from the power supply and clean the contacts.
• The mains lead is not securely plugged into the wall socket.
• Check that the wall socket is energised.
• The charger or mains lead is damaged.
• The battery needs replacing.
9