Printer Connection; Commands - sylvac Hi_Cal 150 Bedienungsanleitung

Printer connection

Certain printers need the LF (Line Feed) command at the end of the data
transmission. Activate Line Feed by menu or RS232.
If the values do not print after sending data, press the FCT key for 2s. (Sends
a Form Feed command to the printer, which allows the buffer to be emptied
and the values displayed.)

Commands

The instrument functions may be controlled externally using the ASCII code
sequence corresponding to the 3 first letters of the function.
Spaces are removed. The message may be in upper or lower case.
The question mark <?> implies an instrument response.
Important: all commands must be followed by a CR (Carriage Return)
Command Corresponds to
?
C
CLE CLEar
CEN?
E
EXT1
EXTernal contact
EXT2
EXT3
EXT4
EXT5
EXT6
16
Function
Send the displayed DIA and CEN value in diameter mode
Reinitialises the maximum / minimum memories
Requests printing of the Centre value
Hold | data output
zero setting
Preset recall
Measurement ↔ Dia
Min ↔ Dia
Clear Min | Max