Fct Key - sylvac Hi_Cal 150 Bedienungsanleitung

Setup
sequence
13.09.13

FCT key

The FCT key can be programmed with different settings depending on type
of measurements.
The different settings are:
FCT1 data output
FCT2 Zero setting
FCT3 preset recall
FCT4 surface ↔ Dia : toggles between surface and diameter mode
FCT5 Surface ↔ Min : toggles between surface and Min | Max mode
FCT6 Clear Min | Max : initializes Min and Max value to probe position
FCT7 Ref 1↔ Ref 2
FCT8 Low ↔ High
FCT9 measure ↔ Diff : difference between the 2 last measurements
10
Function
Software date
CR or CRLF
Printing the diameter or centre in
diameter mode.
: sends displayed value to RS232 and USB
: zero setting
(even if a preset has been entered)
: preset value recall
: toggles ref1, ref2
: toggles between high and low speed ranges
Settings
01.09.10 (jour | mois | année)
Option to add an LF (Line feed),
function needed depending on
the type of printer used. (see
chapter «Printer connection»)
Option selection for printing in
diameter mode:
• Dia, centre
• Dia
• Centre