Measuring Heights; Measuring Upward - sylvac Hi_Cal 150 Bedienungsanleitung

After entering the value for the constant, inverted faces can be measured by
pressing the UP button. Once the probe is in contact with the inverted surface,
both a green light and an acoustic signal will be activated.
Comment : Once the constant has been recorded normal faces (heights) and
inverted faces can be measured equally well.

Measuring heights

Reminder :
• The green light comes ON and an accoustic signal will be heard when the probe-
measurement is ready
• the UP/DOWN button on the back of the instrument controls the movement of
the motorised carriage
• the effect of the UP/DOWN button is stopped as soon as the measurement probe
is in contact with the part to be measured

Measuring upward

Make sure to enter the probe constant before any upward measurement.
origin
Reminder :
• The green light comes ON and an accoustic signal will be heard when the probe-
measurement is ready
• the UP/DOWN button on the back of the instrument controls the movement of
the motorised carriage
• the effect of the UP/DOWN button is stopped as soon as the measurement probe
is in contact with the part to be measured
12
Use the UP/DOWN button on the back of the
instrument to move the motorised carriage until
the measurement probe is in contact with the
base surface (surface table). Press the SET key
to have the zero or preset origin set on this
position.
ref
Move the probe using the UP/DOWN button to the
next measurement position.
Use UP & DOWN button on the back to move the
probe UP and DOWN, until the probe is on contact
with the first surface.
Press SET key to have the zero or preset origin set
on this position.
ref
Move now the probe to the next position to be mea-
sured using the Up & Down button.