First Installation; Preparing For Use; Circuit Priming; Manual Rinsing Cycle - Gaggia Milano VIVA Prestige Bedienungsanleitung

English
10
13 Lid of the water tank
14 Ground coffee measuring scoop
15 Pod filter adapter (specific types only)
16 Coffee pod filter (specific types only)
17 Seat for accessories
18 Seat for coffee measuring scoop
19 Hot water/steam knob
20 Classic milk frother (specific types only)
21 Power cord
22 Main switch (RI8437, RI8435, RI8433) with energy saving switch)

First installation

1 Remove all packaging material from the machine.
2 Place the machine on a table or worktop away from the tap, the sink and heat sources.
Note: Leave at least 15 cm of free space above, behind and on both sides of the machine (Fig. 2).

Preparing for use

1 Remove the lid of the water tank and remove the water tank from the machine (Fig. 3).
2 Rinse the water tank. Fill the water tank with fresh water up to the MAX indication (Fig. 4).
3 Place the water tank back into the machine and push it downwards until the reference marks are
visible (Fig. 5).
4 Place the lid of the water tank back onto the machine.

Circuit priming

When you use the machine for the first time, after dispensing steam or when the water tank is empty,
perform the following steps:
1 Place a container under the milk frother and turn the hot water/steam knob anticlockwise (Fig. 6).
2 Insert the mains plug into a wall socket.Set the main switch to 'I' to switch on the machine (Fig. 7).
-
The power-on light lights up.
3 Turn the selection knob to the coffee position (Fig. 8).
-
Hot water comes out of the milk frother.
4 When the water tank is empty, turn the selection knob back to the standby position (Fig. 9).
5 Turn the hot water/steam knob clockwise. Remove the container (Fig. 10).

Manual rinsing cycle

1 Rinse the water tank. Fill the water tank with fresh water up to the MAX indication (Fig. 4).
2 Place the water tank back into the machine and push it downwards until the reference marks are
visible (Fig. 5).
3 Place a container under the classic milk frother and turn the hot water/steam knob anticlockwise
(Fig. 6).
4 Turn the selection knob to the coffee position (Fig. 8).
-
Let the machine dispense water until the water tank is empty.
5 Turn the selection knob back to standby position (Fig. 9).
6 Fill the water tank with fresh water up to the MAX indication.
7 Insert the pressurized filter holder into the brew unit from below (Fig. 11).
8 Turn the filter holder from left to right as far as possible and release the filter holder grip. The
handle will automatically jump back to the left again (Fig. 12).