Material Code Of Unknown Materials; Entering The Material Code - Wohler HBF 420 Bedienungsanleitung

4.4.3 Material code of un-
known materials
4.4.4 Entering the material
code
Fig. 7: Entering the material code
In order to classify unknown materials more exact-
ly, it is possible to determine the moisture in the
material by means of a drying test. The appropri-
ate code for the material measured is the one
whose setting on the instrument leads most close-
ly to the result indicated by the drying test. If no
drying test is done, we recommend to measure
unknown wood materials with Cd00, though the
measurement may not be precise in this case.

After having switched on the meter press the
Set key (1) three times to bring up the menu
for selecting the material code.
HINWEIS!
After having pressed the Set-key wait approx. 2
seconds before you press it again.
"cd00" and a small "s" as well as the symbols for
the selected measuring modes will appear on
screen.
NOTE!
The correct measuring mode must be selected
before entering the material code (see chapter
4.3).

Enter the correspondent material code with
the up and down keys (2 and 4).

Press the Set key (1) to confirm.
You are now in the menu to enter the alarm
threshold values.
Device
EN
47