Controls And Display - Cameo PAR 64 LED CAN Bedienungsanleitung

1
DMX IN
3-pin XLR socket for connection of a DMX controller (e.g., DMX mixer).
2
DMX OUT
3-pin XLR socket for looping through the DMX control signal.
3
FUSE HOLDER
T2AL / 250 V fuse (5 x 20 mm). IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same
type and rating. If the fuse blows repeatedly, please contact an authorised service centre.
4
MODE
Selection of the standalone functions, DMX modes, and DMX address.
5
ENTER
Makes it possible to change a value and confirm changes.
6
UP AND DOWN BUTTONS
Press the UP and DOWN buttons, for example, to change microphone sensitivity, strobe speed, or
DMX-address.
7
LIT LC DISPLAY
Displays the operating mode and values of individual functions.

CONTROLS AND DISPLAY:

1
4 5
2
3
7
6
7