STIEBEL ELTRON DNM 3 Bedienung Und Installation Seite 36

INSTALLATION
Installation


f Route the power cable through the cable entry in the back f
panel.
f Hook in the appliance cover with the heater at the bottom. f
f Click the heater into place using the snap fastener. f
f Secure the appliance cover with the cover fixing screws. f
Tap installation
Material losses
!
When making the connections, counter the torque on the
appliance using a size 14 spanner.
f Install the tap. For this, also observe the tap operating and f
installation instructions.
36 | DNM
10.2.2 Oversink installation, non-pressurised, with

Tap installation
f Install the tap. For this, also observe the tap operating and f
installation instructions.
!
Appliance installation
f Fit the appliance to the tap with the water connections. f
non-pressurised tap
Material losses
f When making the connections, counter the torque f
on the appliance using a size 14 spanner; see chap-
ter "Installation alternatives / Undersink installa-
tion".
www.stiebel-eltron.com