iSi Nitro Whip Bedienungsanleitung Seite 18

2. Incorrect pressure ratios in the iSi Nitro Whip.
Only use original iSi Nitro Chargers.
Do not reuse empty chargers. They
should be recycled.
Pay attention to only use one charger
regardless the amount of liquid filled in.
Only operate the whipper "headfirst"
with a vertical dispensing tip because
otherwise there could be a loss of pres-
sure.
The head was not firmly screwed onto
the bottle by hand until it was secure.
"Release the pressure" and then set-up
again.
The head gasket was not inserted. "Re-
lease the pressure" and then set-up again.
The dispensing tip was not screwed on.
"Release the pressure" and then set-up
again.
The bottle neck has been damaged.
"Release the pressure." Send the whipper
to iSi or to a service center.
3. The whipper was overfilled.
Observe the maximum filling amounts.
"Release the pressure," pour out the excess
liquid and then set-up the whipper again.
4. The whipper was not shaken or not shaken
enough.
Shake it 6 times.
5. An unsuitable charger was used.
Only use original iSi Nitro Charge.
Pay attention to only use one charger
regardless the amount of liquid filled in
the bottle.
The charger is difficult to screw on or the
charger will not puncture.
1. The charger being used is not suitable.
Only use original iSi Nitro Chargers.
2. The charger was inserted backwards.
Insert the charger correctly (see
illustrations: Instructions for Use).
3. The puncturing unit has been damaged.
Send the whipper to iSi or a service center.
12