Display Functions - Phocos CX48 Bedienungsanleitung

EN It is important that the battery gets fully charged frequently (at least monthly). Otherwise
the battery will be permanently damaged.
A battery can only be fully charged if not too much energy is drawn during charging.
Keep that in mind, especially if you install additional loads.

Display Functions

In normal operation mode the controller displays the state of charge (available energy)
of the battery. Any change of the state of charge (SOC) to a lower status is additionally
signalled acoustically.
System conditions are displayed as follows:
Load disconnect
10..35%
60..80% 35..60% <10%
>80%
Flashes
2x
3x 5x 25x
1x
The percentage corresponds to the available energy until Low Voltage Disconnect in
relation to a fully charged battery.
As long as the solar array supplies enough voltage to charge the battery, this is indicated
by up-moving bars alternately to the state of charge display.
In normal operation the loads can be switched on and off by pushing the button. This
is indicated in the display:
34