Phocos CX48 Bedienungsanleitung Seite 30

Mounting and Connecting the Charge Controller
The regulator is intended for indoor use only. Protect it from direct sunlight and place
it in a dry environment. Never install it in humid rooms (like bathrooms).
The regulator measures the ambient temperature to adopt the charging voltages, therefore
it must be installed in the same room as the battery.
The regulator warms up during operation. It shall be installed on a non flammable
surface only.
REMARK: Connect the controller by following the steps described below to avoid installation
faults.
Open the terminal lid.
27
EN