General Safety Information - Phocos CX48 Bedienungsanleitung

EN

General Safety Information

This manual contains important installation, set up, and safe operating instructions.
Please read the instructions and warnings in this manual carefully before beginning any
installation.
Please do not disassemble or attempt to repair Phocos products. Phocos charge controllers
do not contain user serviceable parts.
Please observe all instructions with regards to external fuses/breakers as indicated.
The information contained in this manual must be observed in its extent. The manual
contains information regarding installation, set up, and operation.
Please read this manual carefully before using the product, and pay special attention
to the safety recommendations in it.
Maintenance and installation notes
When installing or working on the PV system, please disconnect the PV (solar) modules
from the charge controller first, to prevent damages to the charge controller!
Please verify that all cable/wire connections are tightly fastened to the
connectors/connecting posts in order to avoid any bad or loose connections that could
result in excessive heating.
Please install a fuse or breaker near the battery before installing or adjusting the controller!
Please install and operate the controller in a dry environment.
High voltage risks
Operation of this device in conjunction with PV modules may result in voltages of up
to 100 Volt, which could cause servere injuries or death in case of improper installtion
or operation of the device. PV modules can generate high DC voltages!
25