Philips Suncare Sun Mobile HB828 Bedienungsanleitung Seite 9

5 Set the duration of the tanning session (fig. 13).
Press + to put the time forward.
Press - to put the time backward.
Keep the button pressed to adjust the time more quickly.
6 Switch on the tanning lamps (fig. 14).
Press button I. Blinking signal
be shown.
The timer will count down the set session time.
During the last minute of the session, the beeper
During this minute you can press button T to repeat the session time or set a new time.
By doing this, you can avoid the 3-minute waiting time which is necessary to allow the tanning lamps
to cool down after they have been switched off.
7 Lie down under the lamp unit.
Repeating the session time (during the last minute) (fig. 15).
Press button fi.The previously set tanning session time appears on the display.The beeping stops.
Setting a different session time (during the last minute) (fig. 16).
Set a new tanning session time and then press button I.
As soon as this button has been pressed, the beeping will stop and the new session time will start.
If you do not repeat the session time or set a new session time, the tanning appliance will
switch off automatically as soon as the set session time has elapsed.
Extra facilities
Interruption of the tanning session (e.g. to answer a telephone call) (fig. 17).
Press button fi.
-
The tanning lamps are switched off. Blinking signal
The remaining tanning session time blinks on the display.
- After three minutes, the blinking stops.Then, you can switch on the tanning lamps again by
pressing button I.
If you want to use the tanning appliance shorter than the set time: (fig. 18).
Press button I.The tanning lamps are switched off and you can set a new session time;
-
Wait until the time shown on the display stops blinking.Then press button I again.
-
After the tanning session
Keep track of the number of sessions you have had by means of the memory knobs.The
appliance has two memory knobs: one per person.
Let the tanning appliance cool down for 15 minutes before folding it in and storing it.
Storage
1 Wind the mains cord and store it in the storage compartment (B). HB828 only: make sure
the cord and remote control are stored properly too.
Be careful that the cord(s) and the remote control (HB828 only) do not get stuck between the
B
base and the lamp unit when you fold the appliance back into transport position.
2 Release the locking collar for height adjustment (H) by sliding the collar downwards with one
hand. Slide in the stand with the other hand and then release the collar (fig. 19).
3 Turn the lamp unit a quarter turn (fig. 20).
4 Lift the lamp unit a little with one hand and unlock the lamp unit by sliding the two lugs (I)
down with the other hand (fig. 21).
d
will become visible on the display and the preset session time will
f
d
will sound.
disappears from the display.
ENGLISH 9