Sanus VMT35 Handbuch Seite 5

1 Select TV Hardware and Mount TV Brackets
1-1 Select the hardware diameter and length
A
B
1-2 Attach brackets to a TV with a flat back
1-2 Attach brackets to a TV with an irregular back
6901-002150 <00>
Your TV type will help you determine which hardware configuration to use. Match
your type of TV to the suggested hardware configurations in steps 1-2.
A. Installation option without spacers (TVs with flat backs)
B. Installation option using 14 mm or 24 mm spacers (TVs with irregular backs or
recessed holes)
Hand thread screws into the threaded inserts on the back of your TV to determine
the correct screw diameter (M4, M6, or M8).
CAUTION:
Avoid potential personal injuries and property damage!
Verify that there are adequate threads to secure the brackets to the monitor. If
you encounter resistance, stop immediately and contact customer service. Use
the shortest screw and spacer combination to accommodate your needs. Using
hardware that is too long may damage your TV.
In step 1-1, if you selected the:
M4 x 12 mm bolt [07] use the M4 washer [09].
M6 x 14 mm [11] or M8 x 16 mm bolt [14] use the M6/M8 washer [10].
Confirm that the brackets are level on the back of the TV.
Be sure the directional arrow at the bottom of each bracket is pointing upward.
If you require additional space for cables, recesses, or protrusions, choose one of
the configurations in the next step.
M4/M6/M8
[02, 03]
Attach shoulder washers [13] and spacers to the brackets [02], [03].
1. Push the shoulder washer [13] through the appropriate openings of the
brackets [02], [03].
2. Snap shoulder washer [13] into the spacer you selected in 1-1.
Confirm that the brackets are level on the back of the TV. Be sure the directional
arrow at the bottom of each bracket is pointing upward.
1 [02, 03]
2
[13]
[16,
17]
[09, 10]
[07, 11, 14]
M4/M6/M8
[13]
[09, 10]
[13]
[16, 17]
[02, 03]
[08, 12, 15]
5