Important Details For Your Information - WIKA WUC-1 Serie Betriebsanleitung

1. Important details for your information

Read these operating instructions without fail before installing and starting the pressure transmitter.
1. Important details for your information
Read these operating instructions before installing and starting the pressure transmitter. Keep the operating instructions in a
place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care but it is not feasible to take
all possible applications into consideration. These installation and operation instructions should meet the needs of most
pressure measurement applications. If questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de / www.wika.com
■
The product data sheet is designated as PE 87.06
■
Contact WIKA for additional technical support +49 9372 132-0
■
If the serial number on the product label gets illegible (e.g. by mechanical damage or repainting), the retraceability of the
instrument is not possible any more.
WIKA transducers are carefully designed and manufactured using state-of-the-art technology. Every component under-
goes strict quality and environmental inspection before assembly and each instrument is fully tested prior to shipment. Our
environmental management system is certified to DIN EN ISO 14001.
Use of the product in accordance with the intended use WUC-10, WUC-15 and WUC-16:
Use the transducer to transform the pressure into an electrical signal.
For transducer with Ex-marking:
Use the nonincendive transducer of category 3G to transform the pressure into an electrical signal in hazardous areas of zone 2.
Certificate for transducer with Ex and IECEx marking:
Transducer for operation in hazardous areas.
ATEX marking: II 3 G Ex nA ic IIC T6/T5/T4 Gc X
IECEx marking: IECEx BVS 13.0070 X, Ex nA ic IIC T6/T5/T4 Gc
Certificate for transducer with FM marking:
Transducer for operation in hazardous areas in compliance with the respective certificate (see Control drawing No.
11374595, page 44).
FM Approval ratings: Non-incendive for Class I Division 2 Groups A, B, C and D
4
WIKA Operating instructions / Betriebsanleitung, WUC-1x
EN