Functional Test - WIKA WUC-1 Serie Betriebsanleitung

7. Starting, operation
Specifications
RoHS-conformity
CE- conformitiy
Pressure equipment directive
EMC directive
■
ATEX directive of equipment
■
intended for use in potentially
explosive atmospheres
Ex-protection
Ignition protection type
Ex-protection
Ignition protection type
Ex-protection
Ignition protection type
Assembly and packing area
Packaging
Shock resistance
Vibration resistance
Wiring protection
Short-circuit resistance
■
Reverse polarity protection
■
Weight
When designing your plant, take into account that the stated values (e.g.burst pressure, over pressure safety)
apply depending on the material, thread and sealing element used.

Functional test

The output signal must be proportional to the pressure. If not, this might point to a damage of the diaphragm. In that case
refer to chapter 10 „Troubleshooting".
WIKA Operating instructions / Betriebsanleitung WUC-1x
Models WUC-10, WUC-15 and WUC-16
Yes
2014/68/EU
2014/30/EU, EN 61326 Emission (Group 1, Class B) and Immunity (industrial application)
2014/34/EU (for transducer with Ex-marking)
ATEX Category 3G (for transducer with Ex-marking)
II 3G Ex nA ic IIC T6/T5/T4 Gc X (for transducer with Ex-marking)
IECEx
IECEx BVS 13.0070x, Ex nA ic IIC T6/T5/T4 Gc
FM Class I (for transducer with FM-marking)
Nonincendive for use in Class I, Division 2, Groups A, B, C & D, and Class I, Zone 2,
Group IIC, Hazardous (Classified) Locations
Clean room class 5 per ISO 14644
Double bagging per SEMI E49.6
g 500 (1.5 ms) per IEC 60068-2-27
mm 0.35 mm (10 ... 58 Hz) / 5 g (58.1... 2000 Hz) per IEC 60068-2-6
S+ vs. U- (short time)
U+ vs. U-
kg Approx. 0.1
EN
17