AEG S51540TSW1 Benutzerinformation Seite 29

Problem
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
Possible cause
The lamp is in stand-by.
The lamp is defective.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
ENGLISH
Solution
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
29