Connection With The Mains; Connection Between Devices; Operation; Control Board - EuroLite LED Mini D-20 Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

Connection between devices

On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention: It is recommended to renew the connection with the power mains after every 8 devices.

OPERATION

After you connected the EUROLITE LED Mini D-20 Hybrid Beam Effect to the mains, the device starts
running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board or in
DMX-controlled mode via any standard DMX controller. The corresponding LED lights up on the rear of the
housing by the Control Board when the set mode is active (DMX, Auto, Slave, Sound).

Control board

The LED display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.
Microphone sensitivity in Sound Control Mode is adjustable via the rotary control on the rear of the device.
International
L
N
The control board offers several features, i.e. setting the DMX starting address,
running a preset program or selecting a DMX channel mode.
Browse through the menu by pressing MODE. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every
mode by pressing MODE. The functions provided are listed in the following
sections.
24/30 00092113.DOC, Version 1.0