Mounting The Indoor Unit - Sygonix 1698496 Bedienungsanleitung

• The outdoor unit has another connection for a second door opener, for example, for an entrance gate to a property.
It is potential-free, so you need to provide the operating voltage with an external power adapter.
• Insert the indoor unit into the weather protection and screw both tight to the wall using 4 suitable screws (and
dowels, if necessary).
• Finally, replace the front cover on the indoor unit. Secure the cover with a single screw.
• To ensure protection against moisture, add some silicone to the top of the outdoor unit between the aluminium
frame and the wall. Thus the water running down the wall along the cable will be prevented from penetrating the
outdoor unit.
e) Mounting the indoor unit
• It may be necessary to drill holes at the intended installation position depending on the substrate. Mark the appropri-
ate hole patterns through the openings in the wall bracket.
Ensure that you do not damage cables or wires when drilling holes or tightening screws.
• Fasten the wall bracket with suitable screws (and dowels, if required) to the wall. The cables should run through the
opening in the middle of the wall bracket.
• Connect the cables/plugs properly, if you have not already done so, and mount the indoor unit on the wall bracket.
31