Herunterladen Inhalt Inhalt Diese Seite drucken

Plug-In Power Supply; Indoor Unit; Outdoor Unit - Sygonix 1698496 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

b) Plug-in power supply
• The power adapter is manufactured according to Protection Class II.
• The power adapter must be connected to a standard mains socket that is connected to the public grid.
• The mains socket for the power adapter must be near the indoor unit and easily accessible.
• The power adapter is only intended for use in dry, enclosed interiors; it must not get damp or wet. There
is a risk of fatal electric shock!
• Do not unplug the mains adapter by pulling on the cable.
• Protect the cable of the power adapter from sharp edges and do not step on it.
• Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric
shock!
Fully disconnect the mains voltage for the socket to which the mains adapter is connected (e.g. turn
off the corresponding circuit breaker or unscrew the fuse, and then turn off the residual current circuit
breaker).
You can then unplug the power adapter from the mains socket. Replace the damaged plug transformer
with the plug transformer of the same design.
c) Indoor unit
• The indoor unit is only suitable for dry, enclosed indoor spaces. Do not expose it to direct sunlight, heat,
cold, dust, dirt, moisture or wet conditions, otherwise it will be damaged.
• Never cover the ventilation openings on the back.
• Do not apply pressure to the surface of the display, because this can cause not only scratch marks, but
also possible breakage and thus permanent damage to the display. This will void the warranty.
d) Outdoor unit
• The outdoor unit is suitable for indoor and outdoor use (IP55). However, it must never be used in or
under water, as this may destroy the interior components.
• Install the outdoor unit in the outdoor area under an eave (e.g. a canopy).
• Make sure that the connection cable is not pinched or damaged by sharp edges.
• Mount the outdoor unit so that the built-in camera is not oriented directly to bright light sources such as
the sun or a headlight. This will lead to an overexposed image and may damage the image sensor in the
event of constant exposure.
• Before mounting the outdoor unit, observe the applicable regulations as to whether the operation of the
camera or its orientation to a certain surrounding area is permitted.
24

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis