B) Visitor Rings At The Outdoor Unit; C) Operating Door Opener; D) Ring Time Muting; E) Setting The Volume For The Speaker Of The Indoor Unit - Sygonix 1437491 Bedienungsanleitung

b) Visitor Rings at the Outdoor Unit

• If a visitor pushes the bell button on the outdoor unit, the indoor unit will ring. The display is activated, the camera
image appears.
The IR-LEDs in the outdoor unit are automatically activated at low ambient brightness (IR light is not visible
to the human eye). Observe that the colour presentation on the display will change in this case due to the
functional principle.
• Then briefly push the button "
• To activate the door opener, briefly push the "
activated for a few seconds (duration cannot be changed).
• To end the conversation, push the button "
The indoor unit will switch off again automatically after approx. 3 minutes.

c) Operating Door Opener

A door opener can also be activated if no visitor has rung (e.g. if you can see through the window that someone is
walking towards the entrance and you want to let them in.
• Briefly push the button "
• To activate the door opener, briefly push the "
activated for a few seconds (duration cannot be changed).
• Then briefly push the button "

d) Ring time muting

It may be disturbing when someone rings at the door at night. For this reason, you can mute the ring tone.
• Then briefly push the button "
• The LED (18) at the lower right at the indoor unit lights up. This shows the activated muting.
• To deactivate the ring tone muting, push the button "

e) Setting the volume for the speaker of the indoor unit

The volume can be either set in the menu (menu item "AUDIO", see chapter 10. a) or by changing the volume directly
while talking to the visitor by using the buttons "

f) Select ring tone

• Briefly push the button "
• Multiple pushing of the button "
• Then briefly push the button "
34
" (14). You can then talk to the visitor.
" button (13). The door opener connected to the outdoor unit is then
" (14). The display goes out.
" (14); the display is activated and the camera image appears.
" button (13). The door opener connected to the outdoor unit is then
" (14). The display goes out.
" (12).
" (10) or "
" (14); the display is activated and the camera image appears.
" (11) selects one of the 12 ring tones.
" (14). The display goes out.
" (12) again briefly. The LED (18) goes out.
" (9).