B) Enabling The Outdoor Unit From The Indoor Unit; C) Operating The Door Opener; D) Changing The Bell Melody; E) Adjusting The Volume Of The Bell Melody - Sygonix 1698496 Bedienungsanleitung

b) Enabling the outdoor unit from the indoor unit

• If the video door intercom system is in standby mode (no display indication), briefly press the "
camera image will appear.
• Press the " " button (10) to talk to the visitor. The "
• To enable the door opener, press the "
the button pressed.
If you want to enable the second door opener, which opens the entrance gate, press the "
the door opener will remain active as long as you keep the button pressed. While enabling one of the two door
openers, the display goes out.
• If you want to end the call, press the "
go out. The video door intercom system returns to standby mode.

c) Operating the door opener

Activation of a door opener is only possible if the indoor unit monitor displays a camera image.
Proceed as described in chapter 8. a) or 8. b).

d) Changing the bell melody

Changing the bell melody is only possible if the video door intercom system is in standby mode; once
enabled, the interaction with the outdoor unit will not be possible.
• Press and hold down the "
button again.
• To play the next bell melody, briefly press the "
• To save the selection, briefly press the "
mode.

e) Adjusting the volume of the bell melody

Changing the bell volume is only possible if the video door intercom system is in standby mode; once
enabled, the interaction with the outdoor unit will not be possible.
• Press and hold down the "
button again.
• Briefly press the "
desired bell volume.
• To save the current volume setting, briefly press the "
return to standby mode.
" button (9). The door opener will remain active as long as you keep
" button (10). The display of the indoor unit and the "
" button (8) for approx. 4 seconds until a short beep is heard. Then, release the
" button (9). The video door intercom system will then return to standby
" button (8) for approx. 4 seconds until a short beep is heard. Then, release the
" button (10) to adjust the volume and play the current bell melody. In this way, select the
" red LED (3) will go on for control purposes.
" button (8). In this way, select the desired bell melody.
" button (9). The video door intercom system will then
" button (8). The
" button (7). Again,
" red LED (3) will
33