Safety And Protective Devices; Product Overview (01); Approved Cutting Tools - AL-KO BC 225 L-S Betriebsanleitung

GB
2.6

Safety and protective devices

WARNING!
Risk of injury
Defective and disabled
safety and protective
devices can lead to seri-
ous injury.
■
Have any defective
safety and protective
devices repaired.
■
Never disable safety
and protective devices.
Emergency stop
In an emergency, switch off the engine at the ON/
OFF switch.
Guard plate
Protects the operator from contact with the rotat-
ing cutting line and objects flying out.
Loop handle with spacer
Ensures that the feet of the operator do not get
into the vicinity of the rotating cutting line.
2.7

Product overview (01)

No. Component
1 Spool
2 Cutter head
3 Guard plate with line cutter
4 2-piece shaft
5 Loop handle with spacer
6 Combination handle with:
■
7 ON/OFF switch (START/STOP)
■
8 Throttle lever detent
■
9 Throttle lever
10 Engine block with:
■
11 Air filter housing
■
12 Air filter screw
■
13 Primer
34
No. Component
■
14 Fuel tank
■
15 Cap of the fuel tank
■
16 Choke lever
■
17 Starter handle
■
18 Spark plug cover
■
19 Housing flange
2.8

Approved cutting tools

Only the OEM cutting tools listed here may be
used:
■
Spool, Article No. 112880
DANGER!
Danger from cutting
tools!
Non-approved cutting tools
(e.g. multi-part metallic
cutting tools with revolving
chains and blades) and
damaged cutting tools
(e.g. cracks, spalling) can
result in very serious injur-
ies or even death.
■
Use only the approved
OEM cutting tools.
■
Replace damaged cut-
ting tools immediately.
The use of non-approved cutting tools is contrary
to the intended use (see chapter 2.1 "Intended
use", page 32)!
Product description
BC 225 L-S