Start-Up; Mixing And Pouring In Petrol/Oil Mixture (06) - AL-KO BC 225 L-S Betriebsanleitung

Start-up

3. Insert lower shaft half (05/4) into coupling
sleeve (05/5) as far as it will go (05/c). Note:
■
The hollow shaft in the lower shaft half
must engage in the square of the upper
shaft half. Twist upper and lower shaft
half slightly during assembly, if neces-
sary.
4. To release, turn the fixing pin and then push
in until it engages audibly.
5. Tighten the clamping screw again.
Pulling the two shaft halves apart
Proceed in reverse order.
5 START-UP
NOTE
Inspect the appliance for damage every
day before starting work, if it is dropped
or is subjected to other impacts. Have
any damage repaired before putting the
appliance into operation.
5.1

Mixing and pouring in petrol/oil mixture (06)

IMPORTANT!
Danger of engine dam-
age
Pure petrol will result in
damage and complete fail-
ure of the engine. Guaran-
tee claims against the
manufacturer are excluded
in this case.
■
Only operate the engine
using the specified pet-
rol/oil mixture ratio.
Mixing the petrol/oil to produce the mixture
The 2-stroke engine requires:
■
Lead-free, fresh petrol with an octane rating
of at least 90. Petrol stored for longer than 2
months will lead to deposits and malfunctions
of the engine.
■
High-quality synthetic oil for 2-stroke engines
Prepare a petrol/oil mixture in a ratio of 50:1 us-
ing these two constituents:
442377_a
Mixing ratio
50 parts petrol : 1
part 2-stroke oil
1. Pour petrol and 2-stroke oil into a fuel mixing
bottle (quantities, see table, depending on
the size of the fuel mixing bottle).
2. Close the fuel mixing bottle and shake vigor-
ously several times so that the petrol and oil
can mix thoroughly.
Pouring in the petrol/oil mixture
1. Switch off the engine.
2. Place the appliance on a level, horizontal sur-
face. The cap of the fuel tank must be facing
upwards.
3. Wipe fuel tank cap (06/1), fuel tank (06/2)
and the surrounding appliance parts clean so
that no dirt can get into the fuel tank when
the petrol/oil mixture is poured in.
4. Open the fuel tank cap slowly so the pressur-
ised petrol/air mixture can slowly escape
from the fuel tank into the atmosphere. Leave
the cap hanging on the fuel tank.
5. Insert a funnel (06/3) into filler neck (06/4) of
the fuel tank.
6. Pour the prepared petrol/oil mixture from fuel
mixing bottle (06/5) into the fuel tank up to
the lower edge of the filler neck, but not
higher.
7. Remove the funnel and screw on the cap fin-
ger-tight.
8. Wipe any spilled petrol/oil mixture off the ap-
pliance and the surface.
Petrol 2-stroke oil
[litres] [millilitres]
1 l 20 ml
3 l 60 ml
5 l 100 ml
41