3M 33577 Bedienerhandbuch & Sicherheitshinweise Seite 11

GENERAL SET UP AND USE:
• Read all instructions before using this tool . All operators must be fully trained in its use and aware of all safety rules . All
service and repair must be carried out by trained personnel .
• The tool RPM should be checked on a regular basis to ensure proper operating speed .
• Make sure the tool is disconnected from the air supply . Attach the 3M™ Abrasive to the sander adapter using the wrench
supplied with the tool .
• Always wear required safety equipment when using this tool .
• When sanding always start the tool just prior to contacting the work piece . Stop air flow to the tool as it is removed from the
work piece .
• Always remove the air supply to the sander before fitting, adjusting or removing the abrasive .
• Use only 3M approved parts .
• Prior to installing any sanding or polishing accessory, always check that its marked maximum operating speed is equal to or
higher than the rated speed of this tool .
SETTING & TESTING TOOL SPEED:
1 . Ensure the Trigger is not depressed .
2 . Connect the compressed airline .
3 . Press the Trigger slowly and increase force until tool is at full speed .
4 . Use a Rotary Tachometer to check the speed .
5 . Check speed regularly .
Translation of Original Instructions 9