Monuments STEEL Montage- Und Gebrauchsanweisung Seite 29

• Connect the power cable as shown in the wiring diagram.
• There is a wiring diagram attached on the inside of the terminal box.
• Electrical connection shall be made as per Fig. 5 and connection example.
Terminals
Counternut
Cable gland
Terminal box cover panel
• Check that all clamps are tightened properly.
• Close the terminal box with the cover panel again using the four screws. Ensure that the
cover is pushed under the edge of the terminal box as far as possible.
• Align the fastening straps with the given tilting with the holes parallel to the cabin wall
(see Fig. 6).
• Now you can mount the sauna heater with the holes in the chipboard screws that are
already installed in the cabin wall.
Fastening strap
Fig. 6
EN
Fig. 5
29