Technical Specifications; The Following Are Included In The Scope Of Delivery; Sauna Heater Assembly - Monuments STEEL Montage- Und Gebrauchsanweisung

Technical specifications

Power
Electr. connection
Fuse protection
Equipment size (H x W x D)
For sauna cabin size
Min. size air supply and duct vent
Weight without stones and packing
Stone filling
Fuse protection of controller
Connection power supply - power extension
Connection controller - heater
Leakage current
Control unit
Temperature sensor
Intended use
*Mounting height at 25 cm ground clearance.
All cross sections of a line are minimum diameters in mm² (Copper line).
ATTENTION! Installation - 22 cm floor gap to be observed!
To be used with control units: that comply with the Low-Voltage Directive 2014/35/EU and the standards:
DIN EN 60335-1, DIN EN 60335-2-53, DIN EN 62233, DIN EN 62233 Ber.1 and a sauna operation control
range up to max. 115°C, and a sensor system with a safety temperature limiter of max. 142°C

The following are included in the scope of delivery:

• Sauna heater
• Accessories bag with:
1 pc. cable gland PG 13,5 with counter nut
5 pcs. screws 5 x 25 mm
Locking plate
4,5 kW 6,0 kW
400 V 3N AC 50 Hz
3 x 16 A
63 x 40 x 26 (88*) cm
4 - 6 m³ 6 - 8 m³
35 x 3 cm 35 x 5 cm
9,5 kg
15 kg (not included)
3 x 16 A
5 x 2,5
5 x 1,5
max. 0,75 mA je kW heat output
without
without
Sauna heater for use in private saunas
EN
8,0 kW
8 - 12 m³
35 x 5 cm
25